Ignition Coil and Iridium Spark Plugs for BMW 5 Series (2006-2009) 4.8L

Direct-Fit High-Output Ignition Service Kit for 2006-2009 BMW 5 Series

Primary Function: Restores factory spark energy and combustion efficiency across all eight cylinders by replacing worn coil-on-plug units and degraded spark plugs with precision-matched ignition components.

The Stock 5 Series Ignition Degradation

Under the high thermal loads typical of the enclosed engine bay in the E60 chassis, factory ignition coils experience insulation breakdown and thermal fatigue in their internal copper windings. Over time, prolonged heat soak causes primary and secondary winding resistance to drift, leading to intermittent misfires, rough idle, hesitant throttle response, and unburned fuel entering the exhaust stream. Simultaneously, standard electrode wear increases the required firing voltage, straining aging coils and triggering DME misfire trouble codes.

The Engineering Solution

This complete ignition refresh kit features eight high-dielectric coil-on-plug assemblies engineered with high-conductivity internal copper windings, durable silicone boots, and direct-fit blade terminals for continuous high-voltage discharge under extreme engine temperatures. Paired with fine-wire iridium spark plugs offering high melting points and stable gap retention, the system lowers ignition voltage demand, prevents spark blow-out, and delivers consistent flame kernel propagation for reliable cold starts and smooth power delivery throughout the rev range.

Technical Specifications

Compatibility

• 2006-2009 BMW 5 Series 550i Base Sedan 4-Door 4.8L 4799CC V8 GAS DOHC Naturally Aspirated
• 2006-2009 BMW 5 Series 550i Base Wagon 4-Door 4.8L 4799CC V8 GAS DOHC Naturally Aspirated

The BMW Precision Standard

Engineered to satisfy strict European DME diagnostic parameters, these ignition components eliminate rough running and prevent check engine lights (CEL) while preserving factory fuel trim accuracy and seamless V8 throttle response.