Unleash the Heartbeat of America
Founded by racing driver Louis Chevrolet, the "Bowtie" brand has spent over a century defining American performance and durability. From the legendary Small Block V8s to the torque-heavy Duramax diesels, Chevrolet engines are built to work hard and play harder. However, factory tuning often strangles this potential to meet generic fleet standards, leaving your engine feeling restrained.
The GTE Stage 1 Performance Chip is designed to cut the electronic leash. This advanced OBDII module safely optimizes your Chevrolet’s On-Board Computer to release the raw power and efficiency that engineers originally intended. Whether you are towing a heavy load with a Silverado or carving corners in a Camaro, this upgrade delivers the authority your vehicle deserves.
Why Upgrade Your Chevy with GTE Stage 1?
Modern Chevrolets are often plagued by "throttle lag" and conservative shift points. The Stage 1 upgrade revitalizes your driving experience, providing power on demand and better fuel efficiency for the long haul.
-
Revitalized Acceleration: Sharpen 0-60 times and eliminate the hesitation when merging or towing.
-
Maximize Output: Gain up to +20HP and +19.1 ft·lbs of torque.
-
Workhorse Efficiency: Optimize air/fuel ratios for up to +4 MPG increase—massive savings for daily driven trucks and SUVs.
-
Instant Response: Eliminate "drive-by-wire" delay for up to 50% better throttle response.
-
100% Plug-n-Play: Installs in under 5 minutes inside the cabin. No grease, no mechanic required.
Safe for Vortec, LS, LT, and Ecotec Engines
You need a tuning solution that respects the complexity of GM's electronics. The GTE Stage 1 is a sophisticated microprocessor that integrates seamlessly with your ECU. It works safely alongside Active Fuel Management (AFM) and cylinder deactivation systems, optimizing power when you need it and efficiency when you cruise.
Warranty Protected: We understand the value of your investment. This module makes zero permanent modifications. It connects to the OBDII port and can be removed instantly, reverting the vehicle to 100% factory settings. It leaves no digital footprint for the dealer to find, keeping your warranty safe under the Magnuson Moss Warranty Act.
- ✅ Designed and Made in the USA
- ✅ Lifetime Warranty
- ✅ 100% Money-Back Satisfaction Guarantee
Vehicle Compatibility
Our engineers have custom-programmed this module specifically for Chevrolet vehicles (1996 - Present). It is fully compatible with Automatic (including Allison transmissions) and Manual gearboxes.
Supported Models Include:
-
Trucks: Silverado 1500/2500/3500 HD, Colorado, Avalanche, and S-10.
-
SUVs: Tahoe, Suburban, Equinox, Traverse, Blazer, and Trailblazer.
-
Performance: Corvette (C5, C6, C7, C8), Camaro (SS, ZL1, RS), and SS Sedan.
-
Cars: Impala, Malibu, Cruze, Sonic, and Monte Carlo.
-
Engines: Compatible with Vortec V8s, LS/LT V8s, Duramax Diesel, Ecotec 4-cylinders, and V6 models.
Frequently Asked Questions
Do I need tools to install this?
No. This is a seamless "Plug-n-Play" install. If you can plug in a phone charger, you can install this chip. It utilizes the OBDII diagnostic port typically located under the driver's side dashboard.
Will this work with my Duramax Diesel?
Yes! The GTE Stage 1 is highly effective on Duramax engines. By optimizing fuel rail pressure and timing, it can unlock significant torque gains and improve towing fuel economy.
Does it work with Active Fuel Management (V4/V8 mode)?
Yes. The chip is compatible with GM's AFM and Dynamic Fuel Management systems. It does not disable them; instead, it optimizes the transitions and ensures power is available instantly when the engine reactivates all cylinders.
How long until I see results?
You will likely feel a sharper throttle pedal immediately. Full horsepower and MPG gains typically stabilize after about 100 miles (or 2 weeks) of driving as the ECU adapts to the new optimization map.
Wake up your Chevy today. Experience the power you’ve been missing risk-free!