Hubcentric Wheel Spacer Kit for Porsche Taycan (2020-2025) 12mm

Precision-Machined Hubcentric Wheel Spacer Kit for 2020-2025 Porsche Taycan (Y1A)

What it Does: The Hubcentric Wheel Spacer Kit widens track width by 12mm on the 2020-2025 Porsche Taycan to eliminate sunken wheel fitment and increase cornering stability without inducing rotational vibration.

The Stock Porsche Taycan Stance and Track Limitation

Factory engineering on the Porsche Taycan (Y1A) prioritizes ultra-low aerodynamic drag coefficients for range testing, resulting in conservative wheel offsets tucked deep inside broad fender arches. With curb weights exceeding 4,700 to 5,100 pounds across Dual PSM electric configurations, this recessed wheel positioning limits mechanical track width. Under severe lateral loads, the stock track dimension allows more body roll transfer, while visually leaving an unaligned gap between tire sidewalls and exterior fender lines.

The Engineering Solution

CNC-machined from billet 7075-T6 aluminum, this 12mm spacer system delivers exceptional tensile yield strength while maintaining lower unsprung rotational mass than conventional cast alternatives. Engineered with a precision-matched hubcentric snout, the spacer ensures full shear-load transfer directly to the hub snout rather than relying solely on the fasteners. Accompanied by heat-treated, OEM-grade extended wheel bolts, the assembly restores necessary thread engagement and clamping force, preventing radial runout, high-speed vibrations, and stress fractures during high-torque acceleration.

What's Included

• Hubcentric 12mm wheel spacers
• OEM-style extended wheel bolts

Technical Specifications

Compatibility

• 2020-2025 Porsche Taycan Base
• 2020-2025 Porsche Taycan 4S
• 2020-2025 Porsche Taycan Turbo
• 2020-2025 Porsche Taycan Turbo S

Frequently Asked Questions & Fitment Warnings

Does this fit the Y1A Taycan?

Yes, this is a direct fit for the 2020-2025 Porsche Taycan equipped with the Dual PSM powertrain across standard, 4S, Turbo, and Turbo S trims.

What torque specification should be used during installation?

Torque the extended wheel bolts to the factory Porsche specification of 118 lb-ft (160 Nm) in a crisscross pattern using a calibrated torque wrench.

The Porsche Caliber

Engineered to meet stringent European chassis tolerances, these components maintain strict runout boundaries to preserve factory steering feedback, electronic stability control calibration, and high-speed balance.