Ignition Coils for Mazda RX-8 (2004-2011) 1.3L
Die Abholverfügbarkeit konnte nicht geladen werden
- Garantierte Passgenauigkeit
- Leistungsgeprüft
- Lebenslange Garantie
Sie möchten es bald? Bestellen Sie innerhalb von
Sicher einkaufen
Sicherer Bezahlvorgang mit vertrauenswürdigen Zahlungsanbietern.
Direct-Fit 12V Ignition Coil Set for 2004-2011 Mazda RX-8 (SE3P)
What it Does: This 4-piece 12V coil-on-plug ignition coil set restores consistent high-voltage spark delivery across all four ignition positions on the 2004-2011 Mazda RX-8 (SE3P) equipped with the 13B-MSP Renesis 1.3L rotary engine.
The Stock Mazda RX-8 Ignition Coil Failure
On the SE3P chassis, the 13B-MSP Renesis 1.3L rotary engine fires its ignition coils at a much higher duty cycle than a conventional four-stroke piston engine, creating severe under-hood heat soak. Over time, factory coils such as N3H118100 and N3H1-18-100 suffer internal epoxy potting breakdown, thermal cracking, and secondary winding insulation failure. This degrades spark energy, allows unburned fuel to wash down rotor seals, and overheats the catalytic converter.
Common Symptoms of a Failing OEM Ignition Coil
- Check Engine Light / Misfire DTCs: Triggers random or rotor-specific misfire codes such as P0300, P0301, or P0302 from incomplete combustion.
- Hot-Start & Idle Instability: Secondary voltage drop under thermal load causes rough idle, throttle hesitation, and hard starting.
- Catalyst & Economy Degradation: Unburned fuel enters the exhaust stream, reducing fuel economy and risking rotary catalyst damage.
The High-Dielectric Coil-on-Plug Ignition Solution
Replacing all four coils together restores balanced spark output across every ignition position on the 13B-MSP Renesis 1.3L. Each direct-fit 12V coil-on-plug unit utilizes thermally resilient internal windings, an integrated igniter requiring no external resistor, and a factory-matched 3-terminal blade connector. A molded rubber boot creates a tight plug seal, while the single OEM-spec mounting hole bolts straight to the factory mount without wiring modifications.
What's Included
- 4x Direct-Fit 12V Black Coil-on-Plug Ignition Coils (3-Terminal Blade Connector & Rubber Boot)
- Note: Spark plugs, ignition wires, and mounting brackets are not included.
Technical Specifications
| Fitment | 2004-2011 Mazda RX-8 |
|---|---|
| Engine / Chassis | 13B-MSP Renesis 1.3L / SE3P |
| Ignition Architecture | Coil-on-Plug (COP) / 12V Direct-Ignition (No External Resistor) |
| Installation Type | Direct Bolt-On OEM Replacement (No Cutting or Welding) |
| Replaces OEM Part # | UF501, N3H118100, N3H118100A, N3H118100B, N3H1-18-100, IC023, C1459, 5C1450, E1001, 52-1788, 50231, C708, GN10508 |
Compatibility
- 2004-2011 Mazda RX-8 Base (1.3L, Manual & Automatic)
- 2004-2011 Mazda RX-8 Sport (1.3L, Manual & Automatic)
- 2004-2011 Mazda RX-8 Touring (1.3L, Manual & Automatic)
- 2004-2011 Mazda RX-8 Grand Touring / GT / GS (1.3L, Manual & Automatic)
- 2008 Mazda RX-8 40th Anniversary Edition (1.3L, Manual & Automatic)
- 2009-2011 Mazda RX-8 R3 (1.3L)
Frequently Asked Questions & Fitment Warnings
Does this fit the SE3P RX-8?
Yes. This complete 4-coil set is a direct fit for the 2004-2011 Mazda RX-8 equipped with the 13B-MSP Renesis 1.3L engine across manual and automatic transmissions. It does not fit any Mazda RX-7 model.
Will replacing all four coils clear P0300 misfire codes, and are spark plugs or wires included?
Yes, replacing weak coils resolves coil-related P0300 misfires, though spark plugs and ignition wires are not included. Because worn plugs increase secondary load on UF501-spec coils, replacing plugs and wires at the same service interval is recommended.
Do I need dielectric grease or an external resistor for installation?
No external resistor is needed, and a light coat of dielectric grease on the rubber boots aids sealing and future removal. Disconnect the battery, unbolt and unplug the old coils, seat each new boot fully, secure the mounting bolt, and verify all connections before reconnecting power.
The Mazda Precision Performance Standard
Built for the high-RPM thermal demands of the SE3P rotary platform, these replacement coils maintain clean ignition timing and crisp throttle response. Consistent secondary voltage prevents misfire-induced power loss and protects downstream exhaust components under street or track loads.
Passgenauigkeit
Passgenauigkeit
|
Erstellen |
Mazda |
|---|---|
|
Hubraum |
|
|
Jahr |
|
Garantie
Garantie
Für alle Produkte gilt unsere eingeschränkte lebenslange Garantie. Wir stehen hinter unserer Qualität. [Siehe Bedingungen]

Sicher einkaufen
In unserem Shopify-Store legen wir größten Wert auf Ihre Sicherheit. So gewährleisten wir ein sicheres Einkaufserlebnis:
1. Sichere Transaktionen: Wir verwenden fortschrittliche Verschlüsselung, um Ihre persönlichen Daten und Zahlungsinformationen zu schützen und sicher zu übertragen.
2. Vertrauenswürdige Zahlungs-Gateways: Unser Store ist in vertrauenswürdige Zahlungs-Gateways integriert, um sicherzustellen, dass Ihre Transaktionen sicher und effizient verarbeitet werden.
3. Datenschutz: Ihre Privatsphäre hat bei uns oberste Priorität. Wir befolgen strenge Datenschutzrichtlinien, um Ihre persönlichen Daten vertraulich und sicher zu behandeln.
4. Sichere Plattform: Shopify bietet robuste Sicherheitsfunktionen und eine kontinuierliche Überwachung gegen Schwachstellen, um eine sichere Einkaufsumgebung zu gewährleisten.
5. Verifizierte Händler: Wir sind ein verifizierter Händler auf Shopify und verpflichten uns, authentische und qualitativ hochwertige Produkte anzubieten.
6. Transparente Richtlinien: Unsere klaren Rückgabe-, Rückerstattungs- und Versandrichtlinien geben Ihnen die Gewissheit, dass wir hinter unseren Produkten stehen.
7. Kundensupport: Unser engagiertes Kundensupport-Team steht Ihnen bei allen Anliegen und Fragen gerne zur Verfügung.
Kaufen Sie mit Vertrauen in unserem Shopify-Store ein, wo Ihre Sicherheit und Zufriedenheit unsere obersten Prioritäten sind.
$57.95