Engine Motor Mount Set for Honda Accord (2008-2011) 2.4L Automatic

Heavy-Duty Engine and Transmission Mount Set for 2008-2011 Honda Accord (CP2)

What it Does: The Engine Motor Mount Set secures the powertrain assembly on the 2008-2011 Accord to eliminate excessive engine movement, driveline lash, and harsh cabin vibration during idle and acceleration.

The Stock Honda Accord Bushing Degradation & Hydraulic Rupture

The factory mounts on the 8th-generation CP2 chassis are heavily prone to premature degradation caused by prolonged thermal cycling and continuous rotational torque loads. Specifically, the OEM fluid-filled right engine mount regularly ruptures its internal hydraulic membrane under engine movement, resulting in damping fluid loss, metal-to-metal contact, and severe low-frequency harmonics radiating into the cabin. Simultaneously, the factory natural rubber front, rear, and transmission isolators suffer from dry rot, micro-tearing, and petrochemical contamination, causing noticeable engine rock during gear engagement, clunking under load transitions, and excessive stress on the drive axles and exhaust flex pipe.

The Engineering Solution

This comprehensive 5-piece powertrain mounting system is engineered using high-tensile stamped steel brackets paired with oil-resistant, high-durometer elastomer bushings to restore structural driveline rigidity. The right-hand active mount features a reinforced internal hydraulic chamber engineered to absorb primary engine harmonics without structural membrane collapse under load. Each mounting bracket is laser-cut to exact OE tolerances and coated with an anti-corrosion barrier to prevent oxidation. By replacing worn factory dampers with matched durometer elastomeric isolators, this set prevents excessive drivetrain deflection, guarantees precise half-shaft alignment, and restores smooth engine dampening across the entire operational RPM range.

What's Included

• 1 Front Motor Mount
• 1 Rear Motor Mount
• 1 Right Hydraulic Motor Mount
• 1 Lower Transmission Mount
• 1 Upper Transmission Mount

Technical Specifications

Compatibility

• Honda Accord 2.4L Automatic — 2008-2011

Frequently Asked Questions & Fitment Warnings

Does this fit the CP2 Accord?

Yes, this is a direct fit for the 2008-2011 Honda Accord equipped with the K24Z2 / K24Z3 engine. This kit is exclusively for 2.4L automatic-transmission models; it does not fit 3.5L V6 models or manual transmission applications.

What is the correct installation procedure for these mounts?

Support the powertrain with an engine hoist or under-hoist support stand before unbolting factory hardware, and torque all fasteners to OEM factory specifications while the engine is in a neutral resting position.

The Honda Precision Standard

Engineered to handle high-revving i-VTEC torque loads, this replacement mount assembly restores the clean throttle response, sharp gear engagements, and refined cabin isolation expected of Honda engineering.