Short Ram Air Intake For Ford Windstar (1999-2002) with 3.8L V6 Engine Black

Fitment: Ford Windstar (1999-2002) with 3.8L V6 Engine

Features

• Boost horsepower and torque by up to 10%
• Made with T304 lightweight aluminum piping
• Engineered for exceptional filtration and high airflow
• Improves throttle response for a more efficient drive
• Replaces factory air filter and intake tube
• Maximizes airflow through stock manifold system for a deep, sporty sound
• Washable filter requires cleaning only every 50,000 miles under normal driving conditions
• Easy installation with basic hand tools, takes less than 60 minutes
• Will not void vehicle warranty

Rev up the performance of your Ford Windstar (1999-2002) with our Short Ram Air Intake! Our engineering experts have crafted this exceptional system to deliver the ultimate performance upgrade with a guaranteed boost in horsepower and torque. You'll notice the improved power immediately and with our exceptional airflow and filtration, you'll never have to worry about your engine breathing less-than-perfect air. Rest assured, our system will not void your vehicle warranty. Upgrade your factory air box to the best Short Ram Air Intake on the market, and experience the ultimate performance enhancement for your Ford Windstar.

Why change your factory air box for an intake?

- Gain more Horsepower
- Better Acceleration
- Improved Fuel Economy
- Enhanced Sound - A deeper or throaty tone
- Sporty Engine Look
- Spend Less on Filters - Can be cleaned and re-oiled
Installation is fairly easy and only involves removal of your factory air box.
Basic tools are required including screw drivers and socket wrenches to remove the factory air box. You can also search on YouTube for videos showing air box removal for your vehicle.
Most customers can install an aftermarket air intake within 1 hour
It is advised to RESET your battery terminal for a few seconds so your engine computer can re-learn the increase in air flow. Always disconnect your battery when performing engine work.

NO MASS AIRFLOW SENSOR ADAPTER INCLUDED, NOT NEEDED, USE YOUR FACTORY MAF SENSOR TO CONNECT THIS COLD AIR INTAKE AROUND IT.

SEE PICTURES

FIRST, UNPLUG THE BATTERY BLACK NEGATIVE GROUND CABLE

Then unplug the factory MAF sensor

Remove the factory airbox from throttle body

Use the cold air intake metal clamps and black rubber couplers

Connect the tube to the throttle body and factory MAF sensor

Then use clamp and rubber coupler and gasket and place connect it to the air filter cone

Finally, connect the plate to the MAF sensor adapter

Finished. 

10-15 HP Gain

10 foot pounds of torque

2 MPG increase in gas savings

Faster acceleration

Better throttle response

More cooler air breathing for the engine.